Keysight x-series Programmer's Reference

3 VMA Mode
3.5 Channel Power Measurement
Command
[:SENSe]:CHPower:BANDwidth[:RESolution]:AUTO?
Example
:CHP:BAND:AUTO ON
:CHP:BAND:AUTO?
RBW Presets
Mode Preset Value
LTEAFDD
Auto
LTEATDD
Auto
MSR
100 kHz
NR5G
Auto
SA
Auto
SRCOMMS
3.9 kHz
VMA
240 kHz
WCDMA
240 kHz
WLAN
100 kHz
More Information
When Res BW is set to Auto, the bandwidth selected depends on "RBW Filter Type"
on page 851.
Only certain discrete resolution bandwidths are available. The available bandwidths
are dependent on Filter Type or EMC Standard. If an unavailable bandwidth is
entered with the numeric keypad, the closest available bandwidth is selected.
In some PowerSuite measurements, in the LTE-Advanced (both FDD and TDD) and
5G NR modes, when Res BW is in Auto, the resolution bandwidth is predefined
based on the corresponding bandwidth of the single carrier, as shown in the table
below. In the Multi-carrier case, the narrowest RBW among the active carriers is
used.
LTE-A FDD/TDD Modes
Carrier BW Auto RBW, kHz
1.4 MHz 20
3 MHz 43
5 MHz 68
10 MHz 150
15 MHz 220
20 MHz 270
200 kHz (NB-IoT in FDD) 10
5G NR Mode
Vector Modulation Analyzer Mode User's &Programmer's Reference 848

Keysight x-series Specifications

General

Analysis Bandwidth	Up to 1 GHz (depending on model)
Real-Time Bandwidth	Up to 1 GHz (depending on model)
Form Factor	Benchtop
Connectivity	LAN, USB, GPIB
Resolution Bandwidth	1 Hz to 10 MHz (depending on model)