R&S ZNB - Page 781

Command Reference
R&S
®
ZNB/ZNBT
781User Manual 1173.9163.02 ─ 55
Data format
The trace data is transferred in either ASCII or block data (REAL) format, depending
on the FORMat[:DATA] setting. If block data format is used, it is recommended to
select EOI as a receive terminator (SYSTem:COMMunicate:GPIB[:SELF]:
RTERminator EOI).
CALCulate:DATA:ALL?................................................................................................... 781
CALCulate:DATA:DALL?.................................................................................................781
CALCulate:DATA:TRACe................................................................................................782
CALCulate<Ch>:DATA:CALL...........................................................................................782
CALCulate<Ch>:DATA:CALL:CATalog?............................................................................783
CALCulate<Ch>:DATA:CHANnel:ALL?.............................................................................784
CALCulate<Ch>:DATA:CHANnel:DALL?.......................................................................... 784
CALCulate<Ch>:DATA:MDATa:INTerpolate.......................................................................784
CALCulate<Ch>:DATA:SGRoup?.................................................................................... 784
CALCulate<Chn>:DATA..................................................................................................785
CALCulate<Chn>:DATA:NSWeep[:LAST]?....................................................................... 788
CALCulate<Chn>:DATA:NSWeep:COUNt?.......................................................................788
CALCulate<Chn>:DATA:NSWeep:FIRSt?......................................................................... 789
CALCulate<Chn>:DATA:STIMulus?................................................................................. 790
CALCulate:DATA:ALL? <Format>[, <RecallSet>]
Reads the current response values of all traces of the referenced recall set.
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
<RecallSet> Recall set name; if omitted the active recall set is used
Return values:
<Data> Response values either in ASCII or block data format, depend-
ing on the current FORMat[:DATA] setting.
Example: See CALCulate<Chn>:DATA
Usage: Query only
CALCulate:DATA:DALL? <Format>
Reads the current response values of all data traces of the current recall set. Use
CALCulate:DATA:ALL? to query data traces and memory traces.
Query parameters:
<Format> FDATa | SDATa | MDATa
Output format for the S-parameter data, see
CALCulate<Chn>:DATA.
SCPI Command Reference