R&S ZNB - Page 838

Command Reference
R&S
®
ZNB/ZNBT
838User Manual 1173.9163.02 ─ 55
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USEDefault <Boolean>
Delta-L computes the uncertainty in the loss-per-inch calculation at specified frequen-
cies.
This command specifies whether to use the tool's default frequencies or custom fre-
quencies, which can be defined using CALCulate:FMODel:DELT<Ph_pt>:FRE
Quencies:USER commands.
Suffix:
<Ph_pt>
.
This suffix is ignored
Parameters:
<Boolean> ON (1)
Use default frequencies
OFF (0)
Use custom frequencies
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Frequencies" on page 614
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER?
The Delta-L algorithm can calculate the loss-per-inch uncertainties either at default or
at custom frequencies (see CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:
USEDefault).
This command returns the custom frequencies, defined using CALCulate:FMODel:
DELT<Ph_pt>:FREQuencies:USER:ADD etc.
Suffix:
<Ph_pt>
.
This suffix is ignored
Usage: Query only
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Frequencies" on page 614
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER:COUNt?
The Delta-L algorithm can calculate the loss-per-inch uncertainties either at default or
at custom frequencies (see CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:
USEDefault).
This command returns the number of custom frequencies, defined using CALCulate:
FMODel:DELT<Ph_pt>:FREQuencies:USER:ADD etc.
Suffix:
<Ph_pt>
.
This suffix is ignored
Usage: Query only
Options: R&S ZNB/ZNBT-K231
SCPI Command Reference