R&S ZNB - Page 839

Command Reference
R&S
®
ZNB/ZNBT
839User Manual 1173.9163.02 ─ 55
Manual operation: See "Frequencies" on page 614
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER:ADD <UserFrequencies>
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER:DELete <Frequency>
The Delta-L algorithm can calculate the loss-per-inch uncertainties either at default or
at custom frequencies (see CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:
USEDefault).
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER:ADD|DELete adds/
deletes a frequency to|from the list of custom frequencies.
Suffix:
<Ph_pt>
.
This suffix is ignored
Setting parameters:
<Frequency> Custom frequency
Range: The frequency range of the analyzer
Default unit: Hz
Usage: Setting only
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Frequencies" on page 614
CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:USER:DELete:ALL
The Delta-L algorithm can calculate the loss-per-inch uncertainties either at default or
at custom frequencies (see CALCulate:FMODel:DELT<Ph_pt>:FREQuencies:
USEDefault).
This command clears the list of custom frequencies.
Suffix:
<Ph_pt>
.
This suffix is ignored
Usage: Event
Options: R&S ZNB/ZNBT-K231
Manual operation: See "Frequencies" on page 614
CALCulate:FMODel:DELT<Ph_pt>:M1L:CACHe:CLEar:ALL
If the 1-length method is used (CALCulate:FMODel:DELT<Ph_pt>:METHod M1L),
the VNA firmware builds up a cache of coupon measurements (Touchstone files) in the
DeltaL\1LMeasurementCache subfolder of the user data folder
C:\Users\Public\Documents\Rohde-Schwarz\Vna.
This command clears this cache.
Suffix:
<Ph_pt>
.
This suffix is ignored
SCPI Command Reference