Xerox Phaser 6360

Phaser 6300/6350/6360 Color Laser Printer Service Manual 6-5
Adjustments and Calibrations
Restore Factory Margins Settings
You can reset margin settings to the factory-default values.
Caution
Use caution when resetting your margins to the factory-default settings.
Changing these settings back to factory defaults may not be the last-
saved settings if you have previously calibrated your margins.
1. On the Control Panel, select Troubleshooting, and then press the OK
button.
2. Select Print Quality Problems menu, and then press the OK button.
3. Select Calibrate Margins menu, and then press the OK button.
4. Select Restore Factory Settings, and then press the OK button to reset
the margin settings.
Resetting Connection Setup Defaults
Resetting the Connection Setup values sets TCP/IP address, TCP/IP address
menu settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware,
set IPX frame type, IPP, Ethernet speed, Wait Timeout, Page Description
Language, and USB Port selection to their default values.
Caution
Make note of the current network settings or print a Configuration page to
provide a record of the customer’s current network settings before
resetting the connection setup to the factory default values.
1. On the Control Panel, select Printer Setup, and then press the OK
button.
2. Select Connection Setup, and then press the OK button.
3. Select Reset Connection Setup, and then press the OK button to reset
connection defaults.
Resetting Paper Handling Defaults (6300/6350 Only)
Resetting the Paper Handling defaults resets the paper source, 2-sided
printing, tray setup, load paper timeout, tray sequence, custom units and jam
recovery settings to their default values.
1. On the Control Panel, select Paper Tray Setup, and then press the OK
button.
2. Select Paper Handling Setup, and then press the OK button.
3. Select Reset Paper Handling Setup, and then press the OK button.
4. Select Reset Paper Handling Setup NOW, and then press the OK button
to reset the paper handling defaults.