Xerox Phaser 6360

Phaser 6300/6350/6360 Color Laser Printer Service Manual 8-79
Service Parts Disassembly
Development
Developer Frame Assembly (PL7.1.1)
When removing the Developer Frame Assembly, cover the entire assembly
with paper to help prevent toner from spilling onto your clothing. Also, store
the Developer Frame Assembly on a flat surface with its handle upward.
N
o
t
e
Toner will spill from the toner nozzles and the rear of the Developer Frame
Assembly. Keep the assembly vertical to reduce the amount of Toner
spillage. Following the repair, use an approved Type
II Toner Vacuum to
clean spilled toner from the printer and around the work area.
1. Remove the Top Main Cover (page 8-11).
2. Remove the Left Side Cover (page 8-15).
3. Remove the HVPS (page 8-111).
4. Open Door A.
5. Open Door C.
6. Unplug the Imaging Unit CRUM connector (P/J484) at the top of the
Developer Frame Assembly.
7. Release the hooks to disconnect the 4 toner nozzles attached to the
Developer Frame Assembly.
N
o
t
e
Check that the toner nozzle shutter at the end of each Auger Tube is
closed. If the shutter is open; close it.