8-100 Phaser 6300/6350/6360 Color Laser Printer Service Manual
Service Parts Disassembly
LVPS (PL9.1.4)
The Low Voltage Power Supply (LVPS) assembly consists of the power
supply, attached power switch, the AC Inlet Harness, and the surrounding
enclosure.
1. Remove the Top Main Cover (page 8-11).
2. Remove the Right Side Cover (page 8-14).
3. Remove the Left Side Cover (page 8-15).
4. Remove the Rear Cover (page 8-17).
5. Unplug connectors (P/J161, 162, 163, 164, 165) from the LVPS.
6. Remove the 1 screw (silver, 6 mm) that fixes the Power Switch Link
Support Bracket and remove the bracket.
7. Remove the 2 screws (1 metal, 6 mm, and 1 plastic, 10 mm) that secure
the LVPS to the Toner Cartridge Holder Assembly.
8. Remove the LVPS Fan Duct.
9. Remove the 3 screws (metal, 6 mm) that secure the LVPS to the printer
chassis.
10. Remove the screw (self-tapping, plastic 10mm) located at the bottom of
the LVPS, that secures it to Tray 2.
11. Remove the harnesses from the Rear Cable Guide.
12. Remove the screw (self-tapping, plastic 10mm) that secures the Power
Switch Link Shaft support and remove the support.
o
e
In the following step, do not remove the Switch Link Shaft from the printer.
13. Release the Power Switch Link Shaft from the notch in the LVPS and lift
up to remove the LVPS.
Replacement Note
Align the bosses at the base of the LVPS to those on the frame.
To Next Page
Loading...
