Xerox Phaser 6360

A-14 Phaser 6300/6350/6360 Color Laser Printer Service Manual
Reference
Service Diagnostics Tests
Service Diagnostics Tests and Utilities
Test Control Panel Display and Test Definition
Print Service Menu Map - Prints the Service Diagnostics menu then exits diagnostic mode.
General Status - Provides the following print engine status:
General Engine Status No Status To Report
-or one or more
Printer Status Messages (page A-6)
NOTE This is current non-sequential status
since entering diagnostics. If Ready
is reached, Status is cleared.
No Status to Report = the printer is
online and ready to print.
Displays an engine status that will
prevent printing. Status is displayed
one line at a time.
Engine Board ROM
Version
Engine FW: #.#.# or Unknown
Engine NVRAM: #.#.# or Unknown
Option Feeder: #.#.# or Unknown
Displays the engine/feeder firmware
version installed, if known.
Printer Configuration Memory: ###MB
Hard Drive: Not Installed or Installed
HCF/LTA: Installed or Not Installed
Displays current memory installed.
Detects presence of Hard Drive.
Detects presence of option feeder.
Reboot printer to update option
status. Do not lift engine from
optional tray to test.
Ambient Temperature/
Humidity
Temperature: ##
o
C
Temperature: ##
o
F
Humidity: ## %
Displays the current Temperature and
Humidity for the printer.
Fuser Temperature
Temperature: ##
o
C
Temperature: ##
o
F
Displays the printer’s current Fuser
temperature.
Fault History Fault History Display
Fault History Master Clear
List Cleared
Displays Fault occurrence since last
power cycle. Cycle Power displays
following Master Clear.
Test Prints - Prints test prints stored in the Engine Control Board.
Blank Page Print Continuously prints blank pages until
Cancel is pressed.
See “Test Prints” on page 5-5,
“Adjustments” on page 6-3, and
“Resetting NVRAM” on page 6-4, for
specific test print information.
Standard Test Print Continuously prints the Step pattern
until Cancel is pressed.
Custom Test Print Prints the test pattern using the custom
print parameters until Cancel is
pressed.
Current Custom Test
Print Setup
Displays the print setup for the Current
Test Print.
Custom Test Print
Parameters
Set Custom Test Print parameters.