Xerox Phaser 6360

Phaser 6300/6350/6360 Color Laser Printer Service Manual 8-7
Service Parts Disassembly
Maintenance Items and Consumables
Maintenance items include the Transfer Roller, Imaging Unit, and Fuser. The
Paper Feed Rollers are also routine maintenance items, but individual
procedures for their removal and replacement are provided on page
8-20 and
page
8-57. Consumables consist of the four toner cartridges.
Transfer Roller Removal
W
arn
i
ng
If the printer has been in operation recently the Fuser may be hot. Be
careful when you release the latches on the Transfer Roller not to come
into contact with the hot Fuser.
1. Power down the printer.
2. Open Door A.
3. Squeeze the latch at each end of the Transfer Roller and pivot the latch
up.
4. Lift the Transfer Roller out of the printer.
Imaging Unit Removal
1. Power down the printer.
2. Open Door A.
3. Open Door C.
4. Grasp the handle on the top of the Imaging Unit and lift it out of the
printer.
5. Place the Imaging Unit in a light proof bag or other light proof container.
Caution
Leaving the Imaging Unit exposed to light for periods in excess of a 10
minutes can quickly degrade its performance and result in early failure.
Fuser Removal
W
arn
i
ng
The Fuser may be hot. Turn off power and allow at least 10 minutes for
the Fuser to cool before removal.
1. Power down the printer.
2. Open Door B.
3. Lift the Lock Lever on each side of the Fuser, grasp the handles and lift
the Fuser straight up off the mounting studs.