Error Messages and Codes 3-111
Flash Failure
The Flash Memory device on the Engine Control Board has failed.
Applicable Status Codes:
Code U30: Flash Hardware Failure
Code U31: Flash Software Failure
Initial Actions:
■ Cycle the printer's power.
■ If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Engine Control Board, PL1.1.4 ■ Print Engine Map 3 (page 10-6)
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Cycle power to the printer.
Does the error reappear?
Replace the Engine
Control Board
(
page 8-112).
Complete
To Next Page
Loading...
