Xerox Phaser 7400

Adjustments and Calibrations 6-7
Resetting Connection Setup Defaults
Resetting the Connection Setup values sets TCP/IP address, TCP/IP address menu
settings (gateway, broadcast, etc.), CentreWare IS, EtherTalk, Netware, set IPX frame
type, IPP, Ethernet speed, Wait Timeout, Page Description Language, and USB Port
selection to their default values.
Caution
Make note of the current network settings or print a Configuration page to
provide a record of the customer’s current network settings before resetting the
connection setup to the factory default values.
1. On the Control Panel, select Printer Setup, and press OK.
2. Select Connection Setup, and press OK.
3. Select Reset Connection Setup, and press OK to reset connection defaults.
Resetting PostScript Setup Defaults
Resetting the PostScript setup values resets PostScript Error Information, Print-
Quality Mode, TekColor Correction, and Image Smoothing, to their default values.
1. On the Control Panel, select Printer Setup, and press OK.
2. Select PostScript Setup, and press OK.
3. Select Reset PostScript Setup, and press OK.
4. Select Reset PostScript Setup NOW, and press OK to reset the defaults.
Resetting PCL Setup Values to Default
Resetting the PCL setup values resets the default font, pitch, size, symbol set,
orientation, form length, and line termination settings to their default values.
1. On the Control Panel, select Printer Setup, and press OK.
2. Select PCL Setup, and press OK.
3. Select Reset PCL Setup, and press OK.
4. Select Reset PCL Setup NOW, and press OK to reset the defaults.