Error Messages and Codes 3-113
Fuser 110v/220v Mismatch Failure
An error was detected in the Fuser.
Applicable Status Code:
Code U33: Fuser Mismatch Failure
Initial Actions:
■ Cycle the printer's power.
■ If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Fuser PL1.1.21
■ Engine Control Board, PL1.1.4
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Ensure the proper Fuser (110v vs. 220v) is
installed in the printer.
Is the correct Fuser installed?
Replace the Engine
Control Board
(
page 8-112).
Replace the Fuser.
To Next Page
Loading...
