Xerox Phaser 7400 - Printer Error - Contact Service; report fault [n]; Finisher Punch Unit Counter at End of Life

Error Messages and Codes 3-141
Printer Error - Contact Service; report fault [n]
The following procedures apply to codes associated with the Printer Error message.
Finisher Punch Unit Counter at End of Life
The Punch Count indicates that Punch Unit has reached its end of life.
Applicable Status Code:
Code F141: Punch Unit at End of Life
Initial Actions:
■ Cycle the printer's power.
■ If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Punch
■ Punch Control Board
■ Options Map 2 Punch Controller Board
■ Options Punch Controller to Sensor and Motors
■ Options Map 1 Finisher Controller Board
■ Options Finisher Controller to Printer
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Replace the Punch.
Cycle printer power.
Does the error persist?
Replace the Engine
Control Board
NVRAM.
If the error persists,
replace the Engine
Control Board
(
page 8-112).
Complete.