Xerox Phaser 7400

Error Messages and Codes 3-129
Finisher Jog Motor Failure
An error was detected in either the Front or Rear Alignment Motor.
Applicable Status Code:
Code F93: Jog Motor Failure
Initial Actions:
■ Cycle the printer's power.
■ If the problem persists follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack References
■ Paddle Assembly
■ Alignment Motors
■ Options Map 1 Finisher Controller Board
■ Options Finisher Controller to Motors
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1
Check the following for evidence of fault or
damage:
■ Paddle Assembly
■ Alignment Motors
Is there any damage?
Replace any
damaged parts.
Go to Step 2.
2
Test the Alignment Plate Sensors.
Run the Service Diagnostics Front and
Rear Alignment Plate Sensor tests.
Do the sensors function correctly?
Replace the Paddle
Assembly,
Replace the
sensor.