Xerox Phaser 7400

Service Parts Disassembly 8-25
Trays
Tray 1 (MPT)
1. Open the Top Cover.
2. Remove the Front Sensor Board Cover.
3. Disconnect 2 connectors (MPTPAP and MPTSNS) on the Front Sensor Board.
Caution
The hinges are not captive to the tray. In the following steps, use care not to drop
the hinges into the printer when removing the screws.
4. Open Door A.
s7400-423
Front Sensor Board
Tray 1 (MPT) Connectors
Front Sensor Board Cover