Xerox Phaser 7400

8-24 Phaser 7400 Color Printer Service Manual
Top Cover
1. Open the Top Cover completely.
2. Remove 1 (metal, 6 mm) screw from the Fuser Fan duct and remove the duct and
Fan.
3. Disconnect the Fuser Fan connector (P/J250).
4. Remove 3 (black, plastic 6 mm) screws from the left side support arm.
5. Remove 6 (black, plastic 6 mm) screws securing the Top Cover.
6. Release the 3 hooks along the Exit.
7. Remove the Top Cover.
Replacement Note
When replacing the Top Cover, start by aligning the left side of the cover.
There are 2 posts that must slide into springs on the Job Offset Assembly,
then the cover will line up correctly.
Top Cover
s7400-063