Xerox Phaser 7400

8-82 Phaser 7400 Color Printer Service Manual
ADC Sensor
Note
The Registration Shutter return spring is not captive to the shutter. Note the
position of the spring before disassembly.
1. Remove the Registration Sensor Assembly (page 8-80).
2. Turn the assembly over and release the 3 bosses that retain the Registration
Shutter in the assembly.
3. Remove the 1 (metal, 6 mm) screw that secures the ADC Sensor to the assembly.
4. Slide the sensor to the left to release the sensor from the assembly.
5. Disconnect the ADC Sensor connector (P/J192), and then remove the ADC
Sensor.
ADC Sensor
s7400-589
Registration Sensor Assembly