Xerox Phaser 7400

Reference A-27
Reset IU Counts Reset Black IU Count
Resetting IU Count
<Press OK to select value>
<Press Back or Cancel to abort>
Reset Yellow IU Count
Resetting IU Count
<Press OK to select value>
<Press Back or Cancel to abort>
Reset Magenta IU Count
Resetting IU Count
<Press OK to select value>
<Press Back or Cancel to abort>
Reset Cyan IU Count
Resetting IU Count
<Press OK to select value>
<Press Back or Cancel to abort>
No Reset
Reset Fuser
Count
Reset Fuser Count? Y / N
Resetting Fuser Count
<Press Help(?) to toggle choice>
<Press OK to execute reset>
<Press Back or Cancel to abort>
Reset Transfer
Belt Count
Reset Transfer Belt Count? Y / N
Resetting Transfer Belt Count
<Press Help(?) to toggle choice>
<Press OK to execute reset>
<Press Back or Cancel to abort>
Save Engine
NVRAM
Saves Imaging unit life counts,
transfer belt, stapler, punch,
finisher output, electricity needle,
staple needle life counts to
controller NVRAM. Use this
function before replacing the
Engine Control Board.
Restore Engine
NVRAM
Restores previously saved data to
the replacement Engine Control
Board.
IP Controller Diagnostics - Tests the basic functionality of the Image Processor Board
Memory.
RAM Read/
Write Test
Executing..... <approx. 6 seconds per
256MB>
Passed / Failed
Performs an extended memory test
on the Image Processor Board.
NOTE: Cycle power to the printer
after executing this test.
Exit - Exits service diagnostics to PostScript without running power on self test.
Service Diagnostics Tests and Utilities (Continued)
Menu Item Front Panel Display Results Functional Definition