Measurement
109
• Labels and lines of graphs
• File display of the limit test and limit lines
• Background
You set the color of each item by specifying the amounts of red (R), green
(G), and blue (B) contained in the color. You can specify each level of R, G,
and B in 6 steps (0 to 5). Therefore, 216 colors in total are available by
combining them. The table below shows the R, G, and B values for the
main colors as a reference.
R G B R G B R G B
White 5 5 5 Gray 2 2 2 Black 0 0 0
Light red 5 3 3 Red 5 0 0 Dark Red 2 0 0
Light
yellow
5 5 3 Yellow 5 5 0 Dark
Yellow
2 2 0
Light
green
3 5 3 Green 0 5 0 Dark
Green
0 2 0
Light
cyan
3 5 5 Cyan 0 5 5 Dark
cyan
0 2 2
Light
blue
3 3 5 Blue 0 0 5 Dark
Blue
0 0 2
Light
magenta
5 3 5 Magenta 5 0 5 Dark
Magenta
2 0 2
The setting procedure is as follows:
1. Press System > Misc Setup > Display Setup > Color Setup
2. Click Normal (for normal display) or Invert (for inverted display).
3. Click the softkey corresponding to the item for which you want to set
the display color.
Softkey Function
Data Trace 1 to
16
Specifies the data trace of traces 1 to 16
Mem Trace 1 to
16
Specifies the memory trace of traces 1 to 16
Graticule Main
Specifies the graticule label and the outer lines
of graphs
To Next Page
Loading...
