Measurement
389
Procedure
Creating a segment table
1. Press Channel Next/Channel Prev keys to select the channel for which
you want to create the segment table.
2. Press Sweep Setup key.
3. Click Edit Segment Table. The segment table appears in the lower part
of the screen.
4. To change the frequency range setting mode or to set the IF
bandwidth, power level, sweep delay time, sweep mode, sweep time
for each segment, and segment ON/OFF use the following softkeys.
1. When setting the segment table using the front panel keys
or keyboard, you need to place focus on (select) the
operation target (segment table of softkey) first. You can
change the focus by pressing Focus key in the ENTRY
Block. When the focus is placed on the segment table, the
window frame of the segment table is displayed as bright
as the window frame of the active channel. When the
focus is placed on the softkey menu, the softkey menu
title area is displayed in blue.
Softkey Function
Freq Mode
Switches the frequency range setting mode (start/stop or
center/span)
List IFBW
Toggles ON/OFF the IF bandwidth setting for each
segment; the row for setting (IFBW) only appears in the
segment table when this is ON
List Power
Toggles ON/OFF the power level setting for each segment;
the row for setting (Power) only appears in the segment
table when this is ON
List Delay
Toggles ON/OFF the sweep delay time setting for each
segment; the row for setting (Delay) only appears in the
segment table when this is ON
List Sweep
Mode
Toggles ON/OFF the sweep mode setting for each
segment; the row for setting (Sweep Mode) only appears in
the segment table when this is ON
List Time
Toggles ON/OFF the sweep time setting for each segment;
the row for setting (Time) only appears in the segment
table when this is ON
To Next Page
Loading...
Need help?
General
