E5071C
88
a. Press Port Power, then click the softkey corresponding to each
port (Port 1 Power to Port 4 Power).
b. Enter the power level.
Correcting attenuation of power level (using power slope feature)
You can use the power slope feature to correct the attenuation of a power
level so that it is simply proportional to the frequency (attenuation due to
cables and so on), which improves the accuracy of the level actually
applied to the DUT.
Turning power slope feature on/off
1. Press Channel Next/Channel Prev keys to select the desired channel.
2. Press Sweep Setup key.
3. Click Power > Slope [OFF] (Slope [ON]). Each press toggles between
on/off.
Setting correction coefficient (correction amount per 1 GHz)
1. Press Channel Next/Channel Prev keys to select the desired channel.
2. Press Sweep Setup key.
3. Click Power > Slope [xxx dB/GHz] ("xxx" represents the current set
value.).
4. Enter the correction coefficient using the ENTRY block keys on the
front panel.
Setting fixed frequency at power sweep
The procedure for setting the fixed frequency (CW frequency) at the power
sweep is as follows:
1. Press Channel Next/Channel Prev keys to select the desired channel.
2. Press Sweep Setup key.
3. Click Power > CW Freq, then enter the fixed frequency.
Setting CW Time Sweep
The E5071C supports sweep type of CW Time where the E5071C is set to a
single frequency, and the data is displayed versus time. To use the E5071C
in CW time, follow the procedure explained below:
1. Press Channel Next/Channel Prev keys to select the channel whose
sweep range will be set.
2. Press Sweep Setup > Sweep Time, then input the duration of the
sweep which is displayed on X-axis.
3. Click Span, then input the span value as 0 Hz (zero span).
To Next Page
Loading...
Need help?
General
