Using Windows
947
User Account and Password
• To Add Password
• To Add New User
Other topics about Using Windows
To Add Password
At the factory default setting, the password is not set and Auto Log On is
activated.
If you add a password, Auto Log On is not available.
1. Open User Accounts in Control Panel.
2. Click Change an Account.
3. Select your account name ("agena"is the default setting).
4. Click Create a password.
5. Enter you password and password hint.
6. Click Create Password.
To require users to press CTRL+ALT+DELETE before logging on
For added security, you can require users to press CTRL+ALT+DELETE
before logging on.
1. Open User Accounts in Control Panel.
2. Click Change the way users log on or off.
3. Check out Use the Welcome screen.
4. Click Apply Options.
5. Log off Windows.
• ENA must be removed from the domain for the procedure to
work. When shipped, ENA is configured as a member of a
workgroup. If the configuration of ENA is later changed so as to
be a member of domain, then name/password must always be
entered at startup. This is a security requirement of Windows.
• If ENA is assigned to a domain, then Change the way users log on
or off will not be available in User Accounts dialogue box.
• At the log on, you can log in as "agena" or "administrator" (they
are default setting). The password of "administrator" is
"e507xa". "agena" has no password.
To Add New User
To Next Page
Loading...
