Setting Control Functions
745
Setting the Beeper (Built-in Speaker)
• Setting the Operation Complete Beeper
• Setting the Warning Beeper
Other topics about Setting Control Functions
The E5071C has a built-in speaker that sounds a beep tone. The beeper
allows you to make two types of settings.
Type Function
Operation
complete beeper
Sounds a beep tone to inform the user that
operations have completed.
• When calibration data measurements are
done
• When data storage has completed
Warning beeper
Sounds a beep tone to prompt the user to use
caution.
• When an instrument error occurs (An error
message appears at the same time.)
• When a limit test fails
The warning beeper sounds slightly longer than the operation complete
beeper.
Setting the Operation Complete Beeper
1. Press System key.
2. Click Misc Setup > Beeper > Beep Complete to switch the operation
complete beeper on/off.
3. Clicking Test Beep Complete allows you to hear and check the beep
tone of the operation complete beeper.
Setting the Warning Beeper
1. Press System key.
2. Click Misc Setup > Beeper > Beep Warning to switch the warning
beeper on/off.
3. Clicking Test Beep Warning allows you to hear and check the beep
tone of the warning beeper.
To Next Page
Loading...
Need help?
General
