Agilent Technologies E5071C - Saving and Recalling File

Programming
1085
Saving and Recalling File
• Specifying File
• Saving and Recalling Instrument Status
• Saving Measurement Data
• Saving Measurement Data in Touchstone Format
• Saving Images
• Saving and Recalling Segment Sweep Table
• Saving and Recalling Limit Table
• Saving/Recalling Power Sensor Calibration Factor Table
• Saving/Recalling Loss Compensation Table
• Saving/Loading (Importing) a VBA Program
Other topics about Saving and Recalling
Specifying File
When running a command for saving, recalling, and managing files, use a
filename with extension to specify a particular file. Specify "D:" in the
beginning of the file name, when specifying a file on the user area of hard
disk. Also, when specifying a file name with directory, use "/" (slash) or "\"
(backslash) as a delimiter.
Saving and Recalling Instrument Status
You can save the instrument state using one of the following 2 methods:
 Saving the entire instrument state into a file
 Saving the state for each channel into registers A to D (volatile
memory)
Selecting content to be saved
When saving the instrument status into a file or register, the content to be
saved can be selected among the following 4 options:
 Instrument status only
 Instrument status and calibration coefficient array.
 Instrument status, corrected data/memory array (measurement
data)
 Instrument status, calibration coefficient array, and corrected
data/memory array (measurement data)
To select a content to be saved, use the following command:
:MMEM:STOR:STYP
Selecting Content to be Saved