E5071C
58
Basic Measurement Procedures
To better understanding how to use the E5071C, this section describes the
basic measurement procedure using the E5071C and presents an example
of the transmission measurement of a bandpass filter.
Basic Measurement Flow
1. Determining measurement conditions
• Presetting the E5071C
• Select:
• S-parameter
• Data format
• Frequency range
• Number of measurement points
• Power level
• IF bandwidth
2. Calibration
• Specify calibration kit
• Select calibration type
• Measure calibration data
• Make error correction ON
• Save calibartion data
3. Connecting the Device Under Test (DUT)
• Connect DUT
• Adjust the scale
4. Analyzing measurement results
• Analysis using markers
5. Outputting measurement results
• Store measurement file to a disk
To Next Page
Loading...
