E5071C
22
Overview
Front Panel: Names and Functions of Parts
1. Standby Switch
• Used for choosing between power-on ( | ) and standby (O) state
of E5071C.
To turn off the power for the E5071C, be sure to follow the steps described
below:
1. First, press this standby switch or send a shutdown command from
the external controller to activate the shutdown process (the
processing of software and hardware necessary to turn off the power
supply). This will put the E5071C into the standby state.
2. Next, if necessary, turn off power supply to the Power Cable
Receptacle (to LINE) on the rear panel.
• Under normal use, never directly interrupt the power supply to
the power cable receptacle on the rear panel when the power
supply is on. Always keep the Line Switch (Always ON) at (|).
Never turn it off (O).
If you directly interrupt the power supply to the power cable
receptacle when the power supply is on, or turn off the Line
Switch (Always ON), the shutdown process will not work. This
To Next Page
Loading...
Need help?
General
