E5071C
1168
' If data format is Smith chart or polar, set full-scale value
Call viVPrintf(vi, ":DISP:WIND2:TRAC" & CStr(i) & ":Y:RPOS " & CStr(RefPos2(i)) & vbLf, 0)
Call viVPrintf(vi, ":DISP:WIND2:TRAC" & CStr(i) & ":Y:RLEV " & CStr(RefLev2(i)) & vbLf, 0)
Call viVPrintf(vi, ":DISP:WIND2:TRAC" & CStr(i) & ":Y:PDIV " & CStr(Scale2(i)) & vbLf, 0)
End Select
Next i
'
Call viVPrintf(vi, ":MMEM:STOR """ & StaFileName & """" & vbLf, 0) ' Save ENA settings to file
' Close IO
Call viClose(vi)
Call viClose(defrm)
End Sub
Sample Program in HT Basic (setup.htb)
10 DIM Allocate1$[9],Allocate2$[9],File$[20]
20 DIM Para1$(1:4)[9],Para2$(1:2)[9],Fmt1$(1:4)[9],Fmt2$(1:2)[9]
30 REAL Star1(1:3),Stop1(1:3),Pow1(1:3),Cent2,Span2,Pow2
40 REAL Ref_rev1(1:4),Ref_rev2(1:2),Scale1(1:4),Scale2(1:2)
50 INTEGER Segm,Nop1(1:3),Nop2,Num_of_tr1,Num_of_tr2
60 INTEGER Ref_pos1(1:4),Ref_pos2(1:2),I
70 ASSIGN @Agte507x TO 717
80 !
90 Segm=3 ! Number of Segment Ch.1 : 3
100 Star1(1)=1.7E+9 ! Start Frequency Ch.1 Segm.1: 1.7 GHz
110 Star1(2)=1.9E+9 ! Segm.2: 1.9 GHz
120 Star1(3)=2.E+9 ! Segm.3: 2 GHz
130 Stop1(1)=1.9E+9 ! Stop Frequency Ch.1 Segm.1: 1.9 GHz
140 Stop1(2)=2.E+9 ! Segm.2: 2 GHz
150 Stop1(3)=2.2E+9 ! Segm.3: 2.2 GHz
160 Cent2=1.9E+9 ! Center Frequency Ch.2 : 1.9 GHz
170 Span2=5.00E+8 ! Span Ch.2 : 500 MHz
180 Nop1(1)=21 ! Number Ch.1 Segm.1: 21
190 Nop1(2)=101 ! of Points Segm.2: 101
200 Nop1(3)=21 ! Segm.3: 21
210 Nop2=101 ! Ch.2 : 101
220 If_bw1(1)=5.0E+4 ! IF Bandwidth Ch.1 Segm.1: 50 kHz
230 If_bw1(2)=1.0E+4 ! Segm.2: 10 kHz
To Next Page
Loading...
Need help?
General
