E5071C
342
Saving and Recalling Instrument State
• Overview
• Compatibility of Files (Saving and Recalling)
• Saving Data
• Recall Procedure
• Recall Procedure Using "Recall by File Name"
• Priority of Recalling Configuration File at Startup
Other topics about Data Output
Overview
You can save the instrument state of the E5071C into a file on mass
storage and then recall it later to reproduce that state. You can select the
stored data from the following four types.
Type Stored data and usage
State only
(State
Only)
Saves the setting of the E5071C and reproduces the state
when it was saved by recalling it later into the E5071C.
State and
calibration
data
(State &
Cal)
Saves the setting of the E5071C and calibration data
(calibration coefficient array) to reproduce the state when
it was saved by recalling it later into the E5071C. At this
time, you can perform error correction of measured
values by using the recalled calibration data.
State and
trace
(State &
Trace)
Saves the setting of the E5071C and traces (error-
corrected data array and error-corrected memory array)
to reproduce the state when it was saved by recalling it
later into the E5071C. At this time, the traces are also
recalled and displayed on the screen.
State,
calibration
data, and
traces
(All)
Saves the setting of the E5071C, calibration data, and
traces to reproduce the state when it was saved by
recalling it later into the E5071C. At this time, the
calibration data and traces are also recalled.
In addition, the "user-preset" function is provided to allow the user to
freely set up an instrument state recalled when the preset function is
executed.
To Next Page
Loading...
Need help?
General
