E5071C
1088
Recalling the file saved using the above command can reproduce the
segment sweep table on the active channel.
To recall the settings from a file, use the following command:
:MMEM:LOAD:SEGM
• It is possible to recall a file from a different channel where it
was saved. Note that recalling operation is not guaranteed for
the file that might have been modified with editor.
Saving and Recalling Limit Table
Limit table can be saved in the file with CSV (Comma Separated Value)
format. To save limit table on a file, use the following command:
:MMEM:STOR:LIM
Executing the above command will save the limit table for the active trace
of the active channel.
Recalling the file saved using the above command can reproduce the limit
table on the active trace of the active channel. To recall the settings from a
file, use the following command:
:MMEM:LOAD:LIM
• It is possible to recall a file from a different channel or trace
where it was saved. Note that recalling operation is not
guaranteed for the file that might have been modified with
editor.
Saving/Recalling Power Sensor Calibration Factor Table
The power sensor calibration table can be saved in the file with CSV
(Comma Separated Value) format. To save the power sensor calibration
factor table that is set specifically to the E5071C into a file, use the
following commands:
• :MMEM:STOR:ASCF
• :MMEM:STOR:BSCF
Recalling a file saved with the above command can reproduce the power
sensor calibration factor table when it was saved. To recall the settings
from a file, use the following command:
• :MMEM:LOAD:ASCF
• :MMEM:LOAD:BSCF
• Recalling operation is not guaranteed for the file that might
have been modified with editor.
Saving/Recalling Loss Compensation Table
The loss compensation table can be saved in the file with CSV (Comma
Separated Value) format.To save the loss compensation table that is set
for each port into a file, use the following command:
To Next Page
Loading...
Need help?
General
