Programming
2753
SCPI.SYSTem.TIME
Object type
Property (Read-Write)
Syntax
SCPI.SYSTem.TIME = Data
Data = SCPI.SYSTem.TIME
Description
This command sets/gets the time of the clock built in the E5071C.
Variable
Parameter Data
Description
Indicates 3-element array data (time of the built-in
clock).
Data(0): Sets hour (24-hour basis)
Data(1) :Sets minute.
Data(2) :Sets second.
The index of the array starts from 0.
Data type Variant type (Variant)
Range
Data(0) :0 to 23
Data(1) :0 to 59
Data(2) :0 to 59
Resolution 1
Note
If the specified variable is out of the allowable setup
range, the minimum value (if the lower limit of the
range is not reached) or the maximum value (if the
upper limit of the range is exceeded) is set.
Examples
Dim Time As Variant
SCPI.SYSTem.TIME = Array(21,30,0)
Time = SCPI.SYSTem.TIME
To Next Page
