E5071C
2882
Connecting E5071C and Multiport Test Set
• Connecting E5071C (Option 440/445/460/465/480/485) and E5092A
• Connecting E5071C (Option 4D5/4K5) and E5092A
• Connecting E5071C (Option 440/445/460/465/480/485) and E5091A
• Connecting Two Multiport Test Sets
• Recommended Wrench
Other topics about Controlling Multiport Test Set
Connecting E5071C (Option 440/445/460/465/480/485) and
E5092A
Required Devices
The devices required to connect the E5071C (option
440/445/460/465/480/485) to the E5092A configurable multiport test set
are listed below:
• E5071C (option 440/445/460/465/480/485)
• E5092A (option 020)
• Type-N to SMA coaxial adapter (included in the E5092A-08C for
connection with the E5071C, Agilent part number: 1250-2879)
• SMA semi-rigid cable (included in the E5092A-08C for connection
with the E5071C, Agilent part number: E5092-61652)
• USB cable (supplied with the E5092A, Agilent part number: 8121-
1695)
• For the rackmount usage, it is recommended to use semi-rigid
cable (Agilent part number: E5092-61654, included in the
E5092A-08C) for connection with the E5071C.
USB Cable Connections and Driver Installation
1. Connect the USB cable between one of USB ports on the E5071C rear
panel and that of the E5092A.
2. Turn on the E5071C and the E5092A.
3. The Found New Hardware Wizard appears. Select install the software
automatically, then click Next.
To Next Page
Loading...
Need help?
General
