E5071C
456
4. Click 1, 2, 3, or 4 to select the test port from which the network de-
embedding is performed.
5. Click User File.
6. Using the dialog box that appears, select the Touchstone data file
defining the characteristics of the network to be removed. Once the
file is selected, the selection of Select Type automatically changes to
User. To cancel a user-defined file that has been set up, click Select
Type > None.
7. Repeat the procedure to set up the Touchstone data file for each port
from which a network is to be removed.
8. Click De-Embedding to turn the network de-embedding function ON.
9. Click Return.
10. If Fixture Simulator is OFF, press the key again to turn it ON.
To Next Page
Loading...
Need help?
General
