Product Information
875
N4691A 3.5 mm 10 MHz to 26.5 GHz
N4691B 3.5 mm 300 kHz to 26.5 GHz
N4692A 2.92 mm 10 MHz to 40 GHz
N4696A 7 mm 10 MHz to 18 GHz
N4696B 7 mm 300 kHz to 18 GHz
• Firmware A.09.10 or above, enable users to calibrate down to 9
kHz using N4431A (4-port).
• The 9 kHz to 300 kHz performance is valid only for the E5071C
with Firmware revision A.09.10 or above using N4431B.
• When Ecal is used with options 2D5, 4D5, 2K5 and 4K5 and in
the following condition, the waiting time is added automatically.
• Firmware A.09.10: The maximum frequency of your ECal is
over 13 GHz.
• Firmware A.09.20 and above: The maximum frequency of
your ECal is over 13 GHz and the stop frequency on your ENA
set over 8.5 GHz. (The waiting time is NOT added when stop
frequency is set below 8.5GHz.)
• For scalar mixer calibration, the stop frequency of calibration
port is used to determine the waiting time instead of the sweep
stop frequency.
The total waiting time of each calibration type (approximately) is as
follows:
Calibration Type Total waiting time for E5071C (sec)
1-port 9.1
2-port 18.1
3-port 27.1
4-port 36.1
• ENA does not support the following ECal:
Model Name Connector Type Frequency Range
N4693A 2.4 mm 10 MHz to 50 GHz
To Next Page
Loading...
Need help?
General
