Programming
1071
:CALC{1-36}:FSIM:BAL:DMC:BPOR{1-2}:USER:FIL
Differential Port Impedance Conversion
The Differential Port Impedance Conversion feature converts the
measurement results for a balance-unbalance converted differential port to
the characteristics of a different port impedance.
On/Off
To turn on or off Differential Port Impedance Conversion, use the following
command:
:CALC{1-36}:FSIM:BAL:DZC:STAT
You can only turn on or off Differential Port Impedance Conversion for all
of the balance ports, not for each port individually.
Setting the Z0 Value
To set the target differential port impedance, use the following command:
:CALC{1-36}:FSIM:BAL:DZC:BPOR{1-2}:Z0
:CALC{1-36}:FSIM:BAL:DZC:BPOR{1-2}:REAL
:CALC{1-36}:FSIM:BAL:DZC:BPOR{1-2}:IMAG
Sample Program
See Fixture Simulator.
To Next Page
Loading...
