E5071C
1192
160 Limit=10 !limit for corrected data : 10 dBm
170 !
180 ! Presetting the analyzer
190 !
200 OUTPUT @Agte507x;":SYST:PRES"
210 !
220 ! Setting GPIB address of the power meter to E5071C
230 !
240 OUTPUT @Agte507x;":SYST:COMM:GPIB:PMET:ADDR 13"
250 !
260 ! Setting measurement conditions
270 !
280 OUTPUT @Agte507x;":SENS1:SWE:TYPE "&Swp_type$
290 OUTPUT @Agte507x;":SENS1:SWE:POIN ";Nop
300 OUTPUT @Agte507x;":SOUR1:POW:ATT ";Pow_rang
310 OUTPUT @Agte507x;":SOUR1:POW:STAR ";Start_p
320 OUTPUT @Agte507x;":SOUR1:POW:STOP ";Stop_p
330 OUTPUT @Agte507x;":SENS1:FREQ ";Cw_freq
340 !
350 PRINT "Do you perform zeroing and calibrating the power sensor?"
360 PRINT
370 INPUT "[Y/N]",Inp_char$
380 IF UPC$(Inp_char$)="Y" THEN
390 PRINT "Zero and calibrate the power sensor by using the power meter, then press [Enter] key."
400 PRINT
410 INPUT "",Inp_char$
420 END IF
430 !
440 Meas_start: !
450 !
460 ! Connecting the power sensor to the port 1 in the ENA
470 !
480 OUTPUT @Agte507x;"*CLS"
490 PRINT "Set the power sensor connected to the port 1 in the ENA, then press [Enter] key."
500 PRINT
510 INPUT "",Inp_char$
520 !
To Next Page
Loading...
Need help?
General
