Chapter 3 141
Easy Ways to Control Instruments
Configuring an Instrument
Adding the Physical Instrument to the Configuration
1. Select I/O ⇒ Instrument Manager..., and highlight scope.
Under
Instrument... click Properties.
2. Double-click the
Address field to highlight the current entry and type
709. The 7 in 709 is the logical unit. (If the GPIB (HP-IB) logical unit is
not 7, replace 7 with the actual logical unit number.) The
9 in 709 is the
default address for scopes.
3. Click
Advanced: and toggle Live Mode to ON, then click OK. Click OK
to close the
Instrument Properties box.
4. Click
Save to save the changes.
To Next Page
Loading...