Chapter 11 429
Optimizing Agilent VEE Programs
Agilent VEE Execution Modes
To change the execution mode, follow these steps:
1. From the main VEE menu, click
File ⇒ Default Preferences, or
press the Default Preferences button on the tool bar as shown in Figure
11-12.
Figure 11-12. Default Preferences Button on Toolbar
2. In the General folder (already displayed, since it is the first folder),
under
Execution Mode, select VEE 6.0 as shown in Figure 11-13. In
the same folder, make sure that
Disable Debug Features is not
selected. Click
OK.
Figure 11-13. Changing the Execution Mode in Default Preferences
Default Preferences Button
Execution mode
set to VEE 6
Disable Debug
Features turned
OFF (not
checked)
To Next Page
Loading...