320 Chapter 8
Using Agilent VEE Functions
Using Libraries With Agilent VEE UserFunctions
8. Run the program. It should look like Figure 8-19. Save the program as
libraries.vee.
Figure 8-19. Calling a Function from a Library
Note the following about names of merged and imported functions:
n If a merged function has the same name as a local function, VEE displays
an error.
n If an imported function has the same name as a local function, it is
allowed, but the local functions are called if only the function name is
used. You can explicitly call the imported function with the
MyLib_func() syntax as in the Call object in Figure 8-19.
n If two imported libraries have the same function names, the results will
be indeterminate. Notice that the
Call object uses the Library name
myLib.BuildRecAry, so there is no confusion. Even if there were
another local function or other imported function with the same name,
this specifies the name and location of
BuildRecAry.
To Next Page
Loading...
Need help?
General
