Chapter 9 345
Test Sequencing
Passing Data in the Sequencer
Make sure the transaction is highlighted, place the cursor on the
transaction bar, press
Ctrl-K to cut the test, then press Ctrl-Y three times
to paste the test back into the
Sequencer. (You could also cut and paste
using the object menus.)
The default test names will be
test1x2, test1x1, and test1. Open the
three
Sequence Transaction dialog boxes and change these names to
test1, test2, and test3 for clarity.
1. Select
Data ⇒ Continuous ⇒ Real64 Slider and place it to the
left of the
Sequencer. Change the name to the prompt Select Num:,
size the object to be smaller, and connect it to the
Sequencer input
terminal.
Tip: You can size an object as you place it by clicking and dragging the
object corners using the left mouse button.
2. Select an
AlphaNumeric display, place it below the Sequencer,
enlarge it to be wider, and connect it to the
Log output terminal on the
Sequencer.
3. Save the program again as
seqdat1. Select a number on the Real64
Slider
object and run seqdat1. It should look like Figure 9-7.
To Next Page
Loading...