6. EM GUI orientation
The layer system has been optimized in E2 to allow the ma ximum available layer count at all times and can therefore be a bit
confusing.
Based on the La yer mode (set in the System Modifier P anel), the number of “Assign Layer to Destination” varies. The table below
shows the maximum number of single layers for each layer mode.
Maximum nu mber of Single Layers
Mixing Layer Type
E2 E2 Jr.
S3–4K S3–4K Jr.
EX
2K H D 32 16 8 4 NA
Dual Link 16 8 4 2 NA
4K 8421NA
Layers n eed to be assigned to destinations before sources can b e added to the destination.
Output menu
The Output Menu contains four sub-menus: Main , Color, Tim ing and Connector proprties. Adjustm
ents to the Main, Timin g, and
Connector properties are identical with the adjustments to the Main, Timing, and Connector properties in the output configuration
menu. In this des tination configuration menu, however, adjustments can be performed on all or on selected outputs that make up
the destination. Individual outputs can be s elected by clicking on
the corresponding screen. When a screen is selected its outline
turns blue. All outputs can also be selected by clicking on the Select All button.
Image 6-28
Configuration Menu: Destination Adjust—Output (Top of panel)
1Main
2 Color
3 Timin g
4 Connector properties
R5905948 EVENT MASTER DEVICES 17/07/2017 131
To Next Page
Loading...
Need help?
General
