EasyManuals Logo

Cisco Catalyst 4500 Series Command Reference Guide

Cisco Catalyst 4500 Series
1230 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1029 background imageLoading...
Page #1029 background image
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
snmp ifindex clear
2-971
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
2.2
snmp ifindex clear
To clear any previously configured snmp ifindex commands that were entered for a specific interface,
use the snmp ifindex clear command.
snmp ifindex clear
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes Interface configuration mode
Command History
Usage Guidelines Interface index persistence occurs when ifIndex values in the interface MIB (IF-MIB) persist across
reboots and allow for consistent identification of specific interfaces using SNMP.
Use the snmp ifindex clear command on a specific interface when you want that interface to use the
global configuration setting for ifIndex persistence. This command clears any ifIndex configuration
commands previously entered for that specific interface.
Examples This example shows how to enable ifIndex persistence for all interfaces:
Router(config)# snmp-server ifindex persist
This example shows how to disable IfIndex persistence for FastEthernet 1/1 only:
Router(config)# interface fastethernet 1/1
Router(config-if)# no snmp ifindex persist
Router(config-if)# exit
This example shows how to clear the ifIndex configuration from the FastEthernet 1/1 configuration:
Router(config)# interface fastethernet 1/1
Router(config-if)# snmp ifindex clear
Router(config-if)# exit
As a result of this sequence of commands, ifIndex persistence is enabled for all interfaces that are
specified by the snmp-server ifindex persist global configuration command.
Related Commands
Release Modification
12.1(19)EW Support for this command was introduced on the Catalyst 4500 series switches.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals