Cisco Catalyst 4500 Series - Hw-Module Module Stop

2-271
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
hw-module module stop
hw-module module stop
Note The hw-module module stop command is enabled only on the uplink modules of the WS-C4500X-32.
To shut down a module and make it safe for removal, enter the hw-module module stop command:
hw-module module number stop
Syntax Description
Defaults none
Command Modes global configuration
Command History
Usage Guidelines To initiate uplink module OIR w/o pressing the OIR button.
Examples The following example shows what happens if a module is up and you enter the hw-module module
stop command:
Switch# hw-module module 2 stop
Proceed with module stop? [confirm]
Switch#
*Feb 5 16:34:37.325: %C4K_IOSMODPORTMAN-6-MODULEOFFLINE: Module 2 is offline
Switch#show module
Chassis Type : WS-C4500X-32
Power consumed by backplane : 0 Watts
Mod Ports Card Type Model Serial No.
---+-----+--------------------------------------+------------------+-----------
1 32 4500X-32 10GE (SFP+) WS-C4900X-32P-10G JAE153505E9
2 8 Module being held in reset WS-X4908X-10G-TIM JAE15340C0J
M MAC addresses Hw Fw Sw Status
--+--------------------------------+---+------------+----------------+---------
1 0022.bde2.1061 to 0022.bde2.1080 0.2 15.0(1r)SG(0 0.DEV-0 Ok
2 0022.bde2.1579 to 0022.bde2.1580 0.1 In Reset
Switch#
number Uplink module ID. The only applicable value for WS-C4500 is 2.
Release Modification
IOS-XE 3.3.0SG
(15.1(1)SG)
Support for this command was introduced on WS-C4500X-32.