2-310
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip dhcp snooping
ip dhcp snooping
To enable DHCP snooping globally, use the ip dhcp snooping command. To disable DHCP snooping,
use the no form of this command.
ip dhcp snooping
no ip dhcp snooping
Syntax Description This command has no arguments or keywords.
Defaults DHCP snooping is disabled.
Command Modes Global configuration mode
Command History
Usage Guidelines You must enable DHCP snooping globally before you can use DHCP snooping on a VLAN.
Examples This example shows how to enable DHCP snooping:
Switch(config)# ip dhcp snooping
Switch(config)#
This example shows how to disable DHCP snooping:
Switch(config)# no ip dhcp snooping
Switch(config)#
Related Commands
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
ip dhcp snooping information option Enables DHCP option 82 data insertion.
ip dhcp snooping limit rate Configures the number of the DHCP messages that an
interface can receive per second.
ip dhcp snooping trust Enables DHCP snooping on a trusted VLAN.
ip dhcp snooping vlan Enables DHCP snooping on a VLAN or a group of VLANs.
show ip dhcp snooping Displays the DHCP snooping configuration.
show ip dhcp snooping binding Displays the DHCP snooping binding entries.