Cisco Catalyst 4500 Series Command Reference Guide

2-211
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
dot1x credentials (global configuration)
dot1x credentials (global configuration)
Use the dot1x credentials global configuration command to configure a profile on a supplicant switch.
dot1x credentials profile
no dot1x credentials profile
Syntax Description
Defaults No profile is configured for the switch.
Command Modes Global configuration
Command History
Usage Guidelines You must have another switch set up as the authenticator for this switch to be the supplicant.
Examples This example shows how to configure a switch as a supplicant:
Switch(config)# dot1x credentials profile
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands
profile Specify a profile for the supplicant switch.
Release Modification
12.2(54)SG This command was introduced.
Command Description
cisp enable Enables Client Information Signalling Protocol (CISP).
show cisp Displays CISP information for a specified interface.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E