Cisco Catalyst 4500 Series - Debug Ip Dhcp Snooping Event

2-154
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
debug ip dhcp snooping event
debug ip dhcp snooping event
To debug the DHCP snooping events, use the debug ip dhcp snooping event command. To disable
debugging output, use the no form of this command.
debug ip dhcp snooping event
no debug ip dhcp snooping event
Syntax Description This command has no arguments or keywords.
Defaults Debugging of snooping event is disabled.
Command Modes Privileged EXEC mode
Command History
Examples This example shows how to enable the debugging for the DHCP snooping events:
Switch# debug ip dhcp snooping event
Switch#
This example shows how to disable the debugging for the DHCP snooping events:
Switch# no debug ip dhcp snooping event
Switch#
Related Commands
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
debug ip dhcp snooping
packet
Debugs the DHCP snooping messages.