Cisco Catalyst 4500 Series Command Reference Guide

2-828
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
show mac-address-table dynamic
show mac-address-table dynamic
To display the dynamic MAC address table entries only, use the show mac-address-table dynamic
command.
show mac-address-table dynamic [address mac_addr | interface type slot/port |
protocol protocol | vlan vlan_id]
Syntax Description
Defaults This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines The keyword definitions for the protocol argument are as follows:
• assigned specifies assigned protocol entries.
• ip specifies IP protocol.
• ipx specifies IPX protocols.
• other specifies other protocol entries.
The show mac-address-table dynamic command output for an EtherChannel interface changes the port
number designation (such as, 5/7) to a port group number (such as, Po80).
For the MAC address table entries that are used by the routed ports, the routed port name is displayed in
the “vlan” column not the internal VLAN number.
address mac_addr (Optional) Specifies a 48-bit MAC address; the valid format is H.H.H.
interface type slot/port (Optional) Specifies an interface to match; valid values for type are
fastethernet, gigabitethernet, and tengigabitethernet.
protocol protocol (Optional) Specifies a protocol. See the “Usage Guidelines” section for
more information.
vlan vlan_id (Optional) Displays entries for a specific VLAN; valid values are from 1
to 4094.
Release Modification
12.1(8a)EW Support for this command was introduced on the Catalyst 4500 series switch.
12.1(12c)EW Added support for extended VLAN addresses.
12.2(25)EW Added support for the 10-Gigabit Ethernet interface.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E