2-319
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
ip dhcp snooping trust
ip dhcp snooping trust
To configure an interface as trusted for DHCP snooping purposes, use the ip dhcp snooping trust
command. To configure an interface as untrusted, use the no form of this command.
ip dhcp snooping trust
no ip dhcp snooping trust
Syntax Description This command has no arguments or keywords.
Defaults DHCP snooping trust is disabled.
Command Modes Interface configuration mode
Command History
Examples This example shows how to enable DHCP snooping trust on an interface:
Switch(config-if)# ip dhcp snooping trust
Switch(config)#
This example shows how to disable DHCP snooping trust on an interface:
Switch(config-if)# no ip dhcp snooping trust
Switch(config)#
Related Commands
Release Modification
12.1(12c)EW Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
ip dhcp snooping Globally enables DHCP snooping.
ip dhcp snooping information option Enables DHCP option 82 data insertion.
ip dhcp snooping limit rate Configures the number of the DHCP messages that an
interface can receive per second.
ip dhcp snooping vlan Enables DHCP snooping on a VLAN or a group of VLANs.
show ip dhcp snooping Displays the DHCP snooping configuration.
show ip dhcp snooping binding Displays the DHCP snooping binding entries.