Cisco Catalyst 4500 Series Command Reference Guide

2-1078
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
template data timeout (netflow-lite exporter submode)
template data timeout (netflow-lite exporter submode)
Note NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
To specify a template data timeout for the NetFlow-lite collector, use the template data timeout
command. To delete the value, use the no form of this command.
template data timeout seconds
no dscp dscp-value
Syntax Description
Defaults 1800 seconds
Command Modes netflow-lite exporter submode
Command History
Usage Guidelines Default timeout value is 1800 seconds or 30 minutes. The timeout value configured really depends on
the collector and how often it needs the templates to be refreshed.
Examples This example shows how to specify a template data timeout for the NetFlow-lite collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
seconds Specifies a template data timeout value for the NetFlow-lite collector.
Release Modification
15.0(2)SG Support for this command was introduced on the Catalyst 4948E and
Catalyst 4948E-F Ethernet switches.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E