Cisco Catalyst 4500 Series Command Reference Guide

2-86
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
call-home test
call-home test
To manually send a Call Home test message, use the call-home test command in privileged EXEC mode.
call-home test [“test-message”] profile profile-name
Syntax Description
Command Default This command has no default settings.
Command Modes Privileged EXEC mode
Command History
Usage Guidelines This command sends a test message to the specified destination profile. If you enter test message text,
you must enclose the text in quotes (“”) if it contains spaces. If you do not enter a message, a default
message is sent.
Examples This example shows how to manually send a Call Home test message:
Switch# call-home test “test of the day” profile Ciscotac1
Related Commands
“test-message” (Optional) Test message text.
profile profile-name Specifies the name of the destination profile.
Release Modification
12.2(52)SG This command was introduced on Supervisor Engine 6E and the Catalyst
4900M.
call-home (global
configuration)
Enters call home configuration mode.
call-home send
alert-group
Sends a specific alert group message.
service call-home (refer to
Cisco IOS documentation)
Enables or disables Call Home.
show call-home Displays call-home configuration information.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E