Cisco Catalyst 4500 Series - Macro Global Apply System-Cpp

2-449
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release IOS XE 3.4.0SG and IOS 15.1(2)SG)
OL-27596 -01
Chapter 2 Cisco IOS Commands for the Catalyst 4500 Series Switches
macro global apply system-cpp
macro global apply system-cpp
To apply the control plane policing default template to the switch, use the macro global apply
system-cpp global configuration command on the switch stack or on a standalone switch.
macro global apply system-cpp
Syntax Description This command has no keywords or variables.
Defaults This command has no default setting.
Command Modes Global configuration mode
Command History
Examples This example shows how to apply the system-defined default to the switch:
Switch (config)# macro global apply system-cpp
Switch (config)#
Related Commands
Release Modification
12.2(31)SG Support for this command was introduced on the Catalyst 4500 series switch.
Command Description
macro global apply cisco-global Applies the system-defined default template to the switch.
macro global description Enters a description about the macros that are applied to the
switch.